Enerpac P-392 hydraulic hand pump is used to generate hydraulic force, enabling the operation of hydraulic cylinders, tools and equipment. It is suitable for lifting heavy objects, bending metal and pressing components together.
Features:
- Enerpac P-392 2-speed lightweight hand pump reduces worker fatigue through the use of low handle effort.
- It has a glass-filled nylon reservoir and nylon-encapsulated aluminium pump base to resist corrosion, making it ideal in wet environments.
- This Enerpac hydraulic hand pump is equipped with a handle lock for easy carrying.
- Its non-conductive fibreglass handle safeguards operators from electrical shocks.
- This hydraulic hand pump has an internal pressure relief valve to protect against overload.
Compatible Accessories:
- Enerpac 6 feet, 10 feet, 15 feet and 20 feetHose Assemblies: These hose assemblies are engineered to ensure reliable hydraulic fluid transfer and exhibits low volumetric expansion under pressure, which helps maintain the efficiency of the hydraulic system.
- Enerpac RSM-100 Jack Cylinder: This combination offers a powerful and versatile solution for lifting and positioning tasks in tight spaces due to it's minimal height profile.
- Enerpac Single Acting Hydraulic Cylinder: It enables reliable and precise hydraulic lifting and pushing operations. Whether you are tackling heavy-duty tasks or intricate projects, this accessory duo ensures efficiency and accuracy, making it an essential component for your hydraulic toolkit.
Frequently Asked Questions:
Q. How is this Enerpac P-392 2-speed lightweight hand pump better than a single-speed pump?
A. This two-speed hand pump reduces handle strokes by as much as 78% over a single-speed pump, resulting in easier and faster lifting.
Q. How to take care of a hydraulic hand pump?
A.
- Check the pump for leaks and replace the worn-out seals, if any.
- Periodically clean the filters.
- Ensure proper lubrication before use.
Q. How to be safe while using Enerpac P-392 hand pump?
A.
- Avoid overloading the unit.
- Follow proper lifting and positioning techniques.
- Wear adequate personal protective gear.
Q. How to install Intermatic CT2000 percentage cycle time switch?
A.
- Choose where you want to place the timer.
- Loosen the cover screw, lift off the cover, and disconnect the circuit board cable.
- Securely attach the timer using 1 or 2 screws that fit well, at least 8 AWG size (screws not provided). If needed, use a drill to make the lower hole in the base. Once opened, secure the lower hole with a screw. Tighten the screws as needed, but not too much.
- Connect conduit hubs to the conduit before connecting them to the bracket. After inserting the hubs into the bracket, do this step carefully.
- Wire the timer following the National and Local Codes. Make sure Clock Power wiring connections match the specifications for 120 or 240 volts AC input. Adjust SW1 to the right position for 120V or 240V Clock Power (the timer is sent in 240V position).
- Make load connections as shown. Notice that the red wires are connected to isolated relay contacts, allowing the load to get power from a different circuit/voltage than the 'Clock Power'. Supply power to one of the Red wires and connect the other Red wire to your load.
- Connect all ground wires to the grounding lug/screw on the bracket.
- To put the cover back, do step 2 in reverse. Reconnect the circuit board connector and use the cover screw to secure the cover (avoid over-tightening).
- Finally, restore power to the timer at the disconnect or breaker panel.
Q. Does Raptor Supplies offer similar Enerpac hydraulic hand pump with higher pressure rating?
A. Yes, customers looking for hydraulic hand pump with higher pressure rating can opt for Enerpac P2282 hydraulic hand pump having pressure rating of 40000 psi.
